A certified helmet carries a label inside the shell showing the standard it meets, along with a homologation number that identifies the specific model tested. This label is worth checking on any helmet, since it confirms the exact helmet in your hands passed the test, not just the range it belongs to.

This kind of workshop sits closer to a design studio than a factory. Colourways, trims and finishes are developed the way a small run of any crafted object would be, with samples, adjustments and a final sign off before anything reaches a rider.

For replacement visors and care products, see open face helmet.

Once the shell is formed and cured, it moves through finishing: sanding, painting or Hedonist leather trimming, and fitting the internal padding and retention system. Every stage is checked before the next begins, since a fault caught early is far cheaper to fix than one found at the end.

Trying a helmet on in person, and wearing it for a few minutes rather than a few seconds, catches problems a size chart alone cannot. Padding also settles slightly with use, so a helmet that feels snug when new is usually the right call.

ECE 22.06 is the current European standard that motorcycle helmets are tested against, and it replaced the older ECE 22.05 standard with a wider and more demanding set of tests. Helmets are checked for impact absorption at multiple points on the shell, not just the crown, and the standard also tests rotational forces, which earlier standards largely ignored.